R&S ZNA67 - Page 814

GUI reference
R&S
®
ZNA
814User Manual 1178.6462.02 ─ 20
5.19.3.1 Controls on the Remote Settings tab
IP Address
Displays the current IP4 address of the R&S ZNA. By default, the analyzer is config-
ured to use dynamic TCP/IP configuration (DHCP) and obtain all IP address informa-
tion automatically. See Chapter 12.1.2.1, "Assigning an IP address", on page 1640.
The button opens the Windows "Network Connections" system config dialog that
allows you to configure the IP4 (and IP6) settings of your instrument.
GPIB Address
Defines the analyzer's GPIB address. The address must be in the range between 0
and 30.
Remote command:
SYSTem:COMMunicate:GPIB[:SELF]:ADDRess
SYSTem:COMMunicate:GPIB[:SELF]:DCLear:SUPPress
Remote Language
Selects the syntax of the R&S ZNA's instrument control commands.
●
The DEFAULT language corresponds to the commands reported in this documen-
tation; see Chapter 7.3, "SCPI command reference", on page 883.
●
The ZVABT language ensures compatibility with network analyzers of the R&S
ZVA/B/T family. E.g., compared to the DEFAULT language, the command set does
not include INITiate:CONTinuous:ALL and INITiate[:IMMediate]:ALL.
The function of INITiate:CONTinuous and
INITiate[:IMMediate][:DUMMy] is modified; refer to the remote control docu-
mentation in Chapter 7.3.8, "INITiate commands", on page 1170.
●
The ZVR language ensures compatibility with network analyzers of the R&S ZVR
family. See also Chapter 7.5, "R&S ZVR/ZVABT compatible commands",
on page 1564.
●
PNA, ENA, HP8510, HP8720, HP8753 ... denote command sets for network ana-
lyzers from other instruments or manufacturers.
Setup softtool