R&S ZNA67 - Page 962

Command reference
R&S
®
ZNA
962User Manual 1178.6462.02 ─ 20
Parameters:
<Unit> POWer | VOLTage
Power or voltage units
*RST: POWer
Example:
CALC4:PAR:SDEF 'Ch4Tr1', 'b1'
Create channel 4 and a trace named Ch4Tr1 to measure the
wave quantity b
1
. The trace becomes the active trace in channel
4.
CALC4:FORM:WQUT VOLT
Select voltage units for the created trace (identified by the suffix
4).
Manual operation: See "Display unit" on page 318
7.3.1.10 CALCulate:GDAPerture...
The CALCulate:GDAPerture... commands configure the group delay measure-
ment.
CALCulate<Chn>:GDAPerture:SCOunt <Steps>
Defines an aperture for the calculation of the group delay as an integer number of fre-
quency sweep steps.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Steps> Number of steps
Range: 1 to 10000
*RST: 10
Example:
*RST; :CALC:FORM GDEL
Select group delay calculation for the active trace.
CALC:GDAP:SCO 15
Select an aperture of 15 steps.
Manual operation: See "Aperture Points" on page 379
7.3.1.11 CALCulate:IAVerage
CALCulate<Chn>:IAVerage[:STATe] <Boolean>
Turns infinite averaging on or off.
The averaging mode can be selected using CALCulate<Chn>:IAVerage:MODE.
Suffix:
<Chn>
.
Channel number used to identify the active trace
SCPI command reference