5-20 hsb
2
PLUS Series LCD Display
Creating a New Route
Note: You can position the cursor on an existing waypoint – the cursor text
WPT indicates you are re-using the waypoint rather than placing a new one.
This waypoint is included in the route when you press PLACE WAYPOINT.
The waypointappears on the screen at the cursorposition. The number
displayedalongsidethe waypoint identifies its position in the route.The
new waypoint is temporarily added to the waypointlist with the firstavail-
ablewaypoint number. Thewaypoints in the currentroute are re-num-
beredto identify the new positions.
Note: If you Clear the route before it is Saved, the waypoint is removed.
4. Move the cursor to the next waypoint position. A dotted line connects the
cursorto the last placed waypoint.
5. Press PLACE WAYPOINT again. The waypoint is placed and the dotted line
changesto a solid line.
If you placed thewaypoint incorrectly, you can delete the last-placed way-
point by pressing the UNDO WAYPOINT soft key.
6. Repeatsteps 4 and 5 until you have placed all your waypoints. You can
have up to 50 waypointsin a route.
7. When you have entered all your waypoints:
Pressthe ACCEPT ROUTE soft key (or ENTER) to complete the route. Your
routeis displayedon the screen,and is the current route,but itis not active.
The firstwaypoint of anew route is outlined with a square, indicating that
it will be the target waypoint when the route is activated.If selected,the
waypointdata box is displayedfor the target waypoint.
You can save the route as describedbelow.
Note: The completed route is stored in the display unit, and will be re-dis-
played if you turn the unit off and on again. However, on an integrated system
it is possible for a current route from another unit to overwrite this route; it is
therefore recommended that you Save the route as described below.
➤ To make a new route using the Waypoint List:
1. Press the ROUTE soft key; the route soft keys are displayed.
2. Press the MAKE ROUTE soft key; the make route soft keys are displayed.
PLACE
WAYPOINT
UNDO
WAYPOINT
ACCEPT
ROUTE
D4167-1A
MAKE
ROUTE
EDIT
ROUTE
CLEAR
ROUTE
MORE¬
D5575-1
PLACE
WAYPOINT
UNDO
WAYPOINT
ACCEPT
ROUTE
USE
WPT LIST
81186_3.book Page 20 Thursday, August 22, 2002 8:23 AM
To Next Page
Loading...
