Chapter 7: Setting Up the System Defaults 7-1
Introduction
Chapter 7: Setting Up the System Defaults
7.1 Introduction
Once you have installed your display unit and are familiar with its basic
operation(describedinChapter 1 and Chapter 2),youneedtosetitupsothat
itobtainsthecorrectinformationfromtheequipmentyouhaveconnecteditto,
operatesaccordingto your requirements,and displays informationaccording
to yourpreferences.
Thisis achievedusing the soft key controlsthat are displayed when you press
the MENU key.
Inmost cases,you willonly need to usethe MENU keyoptionswhenyou first
set up your system. However, you may decide to change the way you have
customized some aspects, suchas the screen and helpsetting,as you become
more familiarwith your system.
Onceyouhavesetthevalues,theyremainasthedefaultsettingsuntilyoureset
them; they are retainedeven if you power off your display.
This chapter covers the following topics:
• Changingthe defaultset up parameters
• System parameterfunctions and default settings
• Radar-specific parameter functions and default settings
• MARPA specific parametersand defaultsettings
• AdvancedRadar functions
• Chartspecificparameterfunctionsand defaultsettings
You should check the functionsof the parameters,and decide on thenew
settings, before making the changes.
Note: The SYSTEM SET UP menu option from the chartplotter display is the
same as that accessed from the radar display SYSTEM SET UP menu.
MENU
81186_3.book Page 1 Thursday, August 22, 2002 8:23 AM
To Next Page
Loading...
