Chapter 3: Standard Radar Operations 3-11
Changing the Targets
Display
Changing the Targets Display
The PathfinderPLUS Radar allows you to improve targetvisibility by
changingthe following:
• Interference rejection
• Target expansion
• Target wakes
Theseparametersare accessedfrom the default soft key TARGETS.
Thissection explainshow to change these modes and describes the effect of
eachmode. The currentsettings are shown at the right-hand end of thestatus
bar as shown in Figure 3-9.
Figure 3-9: Status Bar
➤ To changethe settings of the targetmodes:
1. Press the TARGETS default soft key.
The target option soft keys are displayed,with the current selections high-
lighted.
2. Pressthe appropriate soft key to toggle therequired settingbetweenOFF
and ON.
Note: If an option is not available for the current setting, its soft key label is
grey. When you press the key, the system beeps and the setting remains OFF.
For the Wakesmode, press the WAKES soft key to step the highlighted
selection through the wake options.
You can use the soft keys to change the settingsof any or all the modes on
thisdisplay.
3. When the requiredoptions are highlighted, press ENTER. The screen
returnstothedefaultdisplaywiththenewmode(s)inoperation.Thestatus
bar is updated to indicatewhich controlsare switched on.
D3986-3
Wakes on Target Expansion on
Status Bar
Interference Rejection on
3nm
126°T
AUTO
WKS
FTC
EX
RC
GZ
IR
RR
1/2
H-UP
GST
TM TV3
D3642-3
TARGETS
INT REJ
OFF ON
EXPANSION
OFF 1 2
WAKES
OFF S M L
CLEAR
WAKES
WAKES
OFF S M L
81186_3.book Page 11 Thursday, August 22, 2002 8:23 AM
To Next Page
Loading...
