Chapter 9: Maintenance and Problem Solving 9-3
Problem Solving
9.3 Problem Solving
All Raymarine productsare, prior to packing and shipping, subjected to
comprehensive test and qualityassuranceprograms.However, if this unit
shoulddevelop a fault, please refer to the following table to identify the most
likelycause and the correctiveaction required to restore normal operation.
Ifyoustillhave a problemafter referringto the table below, contactyour local
dealer, national distributor or Raymarine Technical Services Department for
furtheradvice.
Alwaysquote the product serial numbers. The display unit serial number is
printedon the back of the unit.
Common Problems and Their Solutions
Technical Support:
Please visit out website at:
www.raymarine.com/recreational/support
whereyouwillfindaQuestions&Answersdatabase,serviceinformationand
e-mail access to the TechnicalSupport department.
Alternatively, if you don’t have access to the world wide web, call:
1-800-539-5539 extension 2444 or
(603) 881-5200 extension2444
Our Technical Support Specialists are availableto answer questions about
installing,operating and trouble-shooting all Raymarine products.
Table 9-2: Common Problems
Problem Correction
Display does not function 1. Make sure that the power supply cable is sound and that
all connections are tight and free from corrosion.
2. Check the system fuse.
“Scanner not responding” message Check that the cable connecting the scanner to the radar
display unit is firmly attached and undamaged.
The bearing displayed on the radar
display is not the same as the actual
bearing.
Perform the bearing alignment procedure described in
Section 8.7, Radar System Tests and Installation Alignment
81186_3.book Page 3 Thursday, August 22, 2002 8:23 AM
To Next Page
Loading...
