Raymarine hsb2 PLUS Series - Raystar 114 Combined GPS and Differential Beacon Receiver

Appendix B: Using the Auxiliary Junction Box B-5
Raystar 114
Combined GPS and
Differential Beacon
Receiver
Raystar 114 Combined GPS and Differential Beacon
Receiver
To connect your Raystar 114 CombinedGPS and Differential Beacon
Receiverto your display,cut off the 5-pin connector, strip back the insulation
on all the wires and connect to the Auxiliary Junction Box as shown in the
illustration below.
CAUTION:
Ensure the correctpolarityof the 12 V supply beforeapplyingdisplay or
SeaTalk power. It is recommendedthat a multimeter is used to check the
connections.
Note:You can use the GPS Set-Uppage tomanually tune theRaystar 114.Re-
fer to Chapter 6 for details.
12V
Power
Supply
(fused)
From
Combined
GPS/DBR
sensor
Green
Red
Black
To Display Unit
SeaTalk Socket
D4301_1
Red
Black
White
Yellow
81186_3.book Page 5 Thursday, August 22, 2002 8:23 AM