Chapter 5: Standard Chart Operations 5-9
Placing a Waypoint
• Moving a Waypoint
At the end is a section about using the ST60/80 Navigator Keypad to select,
edit,and name your waypoints.
Placing a Waypoint
The scenarioPlace and Goto a Waypoint on page 2-24 providesa simple
exampleof how to place a waypoint.
➤ To access the place waypoint soft keys, press MARKS:
➤ To placea waypoint at the cursor positionor at the vesselposition:
1. Press either the PLACE WPT AT CURSOR or the PLACE WPT AT VESSEL soft
key. The waypoint is added to the waypoint listand tagged using the next
available number.
Thewaypointsoftkeysaredisplayeduntilyoumovethecursorawayfrom
the waypoint or press CLEAR.
You can use the EDIT WAYPOINT soft key to name the waypoint as
describedin Editing Waypointsbelow.
2. Press CLEAR or ENTER to remove the place waypointsoft keys.
➤ To placea waypoint as latitude/longitudeusing the WaypointList:
1. PressMA RKS,followedbytheWAYPOINT LISTsoftkey.TheWaypointList
and associatedsoft keys are displayed.
2. Press the MAKE NEW WAYPOINT softkeyfollowedbythe LAT/LONG soft
key;theWPT POSITION (LAT/LONG) screenisdisplayed,withit’sassociated
softkeys. The waypoint is placed at the current vessel position,or if not
available, the cursor position.
D4169-1
PLACE WPT
AT CURSOR
PLACE WPT
AT VESSEL
WAYPOINT
LIST
MARKS
D5572-1
PLACE WPT
AT CURSOR
PLACE WPT
AT VESSEL
WAYPOINT
LIST
LOAD/SAVE
USER CARD
MARKS
PLACE WPT
AT CURSOR
PLACE WPT
AT VESSEL
D4163-1
GOTO
WAYPOINT
EDIT
WAYPOINT
ERASE
WAYPOINT
MOVE
WAYPOINT
MARKS
WAYPOINT
LIST
MAKE NEW
WAYPOINT
81186_3.book Page 9 Thursday, August 22, 2002 8:23 AM
To Next Page
Loading...
