Chapter 2: Getting Started & Adjusting the Display 2-5
Simulator Mode
Figure 2-4: Switch Off
When the counter reacheszero a beep sounds, and the display unit switches
off. Releasethe POWER key.
Note: Switch the display unit off before you remove the power cord.
Note: You do not need to change to Standby mode before turning off the dis-
play:if you turn the radar display off while it is in Transmitmode, the scanner
is also de-activated.
Simulator Mode
When simulator mode is on a simulator data box is displayed.
Whenthedisplayisswitchedoffthenonagain,simulatormodeismaintained.
It is recommended that you select the System Set Up Menu and switch off
simulatormode when you have finished.
➤ To viewa simulated image:
1. Press MENU followed by the SYSTEM SET UP soft key.
The set up menupop-up is displayed.
2. UsethetrackpadtomovetheselectionbarovertheoptionSIMULATOR.The
simulatorsoft keys are displayed.
3. In the system set up menu, press RADAR to view a simulatedradar image,
DATA to view thechart displaywith simulated position,or BOTH to view
simulatedradar and chart data.
4. Press ENTER twice to return to the default display.
Note: Any waypoints placed on the chartplotter in simulator mode are re-
tained in the database list and are available for use in routes.
DISPLAY
GAIN
VRM/EBL
MULTI
MARKS
ALARMS
RANGE
ENTER CLEAR MENU
POWER
Countdown timer:
number of seconds
to power off
SECONDS
3
D3599-1
POWER OFF IN
3s
MENU
SYSTEM
SET UP¬
81186_3.book Page 5 Thursday, August 22, 2002 8:23 AM
To Next Page
Loading...
