Chapter 5: Standard Chart Operations 5-15
Using the ST60 or
ST80 Navigator
Keypad
CAUTION:
Take carewheneditingwaypointsasitispossibletomove waypoints that
are used in routesstoredin the Route Database. In such instances,the
storedroutewill includethe waypoint in its new position.List.
➤ To move a waypoint using the cursor:
1. Movethecursoroverthewaypoint,untilthelettersWPT aredisplayed.The
waypointsoft keys aredisplayed.
2. Press MOVE WAYPOINT, the cursor changes to a four-headedarrow.
3. Move the cursor to the requiredwaypoint position.
Press ENTER to set the positionand return to normal cursor control.
Press CLEAR to cancel the operation.
➤ To move a waypoint using the Waypoint Edit functions:
1. Selectthewaypointusingeitherthecursororthewaypointlistasdescribed
above.The waypoint soft keys are displayed.
2. To edit the waypoint position proceedas previouslydescribed in Editing
the Waypoint Details on page 5-13.
Using the ST60 or ST80 Navigator Keypad
If you have an ST60 or ST80 NavigatorKeypad connectedon SeaTalk it can
beused to name or edityour waypoints,tracks,or routeson any display in the
system.ThekeypadcanalsobeusedtoselectentriesintheWaypointList.The
Navigatorprovides10dedicatedalphanumerickeys,amultidirectionalcursor
control pad, plus Insert and Delete keys. The small red LED glows when the
keypadis operational.
Note:When using the Navigator Keypad,you should be aware thatit can con-
trol several displays simultaneously; any display in edit mode (i.e. ready for
alpha-numeric data entry) will be affected by the Navigator Keypad.
Figure 5-5: ST80 Navigator Keypad
WPT
MOVE
WAYPOINT
D1934-2
2
def
3
ghi
1
abc
5
mn
6
opq
4
jkl
8
uvw
9
xyz
7
rst
0 del
ins
NAVIGATOR
81186_3.book Page 15 Thursday, August 22, 2002 8:23 AM
To Next Page
Loading...
