Chapter 5: Standard Chart Operations 5-33
Stop Follow or Stop
Goto
2. Press the GOTO WAYPOINT soft key.
Navigationto the selectedwaypointbegins.The softkeySTOP GOTO is dis-
played.
3. To returnto the defaultsoft key display, move the cursor away fromthe
waypointorpressENTER orCLEAR.
➤ To navigatedirectly to the cursor position:
1. Use the trackpadto positionthe cursor as required.
2. Press the GOTO default soft key, followed by GOTO CURSOR.
If navigationis currently in progress you are warned “Already following
route.Cancel routeand goto cursor?”.
To cancel the GOTO CURSOR operation,press NO.
To continuewith the GOTO CURSOR operation(and stopthe currentGOTO
ROUTE), press YES.
The chartplotter places a temporary waypoint as the targetand starts to
navigatetowards it. The waypoint is shown as a squarewith a circle and
dot in the centre, and is connected to the vessel’s starting position with a
dashedline.
The soft key STOP GOTO is displayed.
3. To returnto the defaultsoft key display, move the cursor away fromthe
waypointorpressENTER orCLEAR.
Stop Follow or Stop Goto
➤ To stopfollowingthe route or target point
either:
1. If necessary, press theGOTO soft key, then press the STOP GOTO/FOLLOW
softkey.
Or:
1. Move the cursor over any waypoint or leg in the current route,then press
the STOP GOTO/FOLLOW soft key.
The dottedline from your vessel to the target waypointdisappears.
If you stoppeda GOTO WAYPOINT orCURSOR, to removethe target point from
thescreen, move the cursor over the target point then press the CLEAR GOTO
soft key.
If you subsequently use the FOLLOW ROUTE soft key to restartnavigation, the
routeis followedfrom the point at whichitwas stopped.Thisisindicatedby a
squarearound the targetwaypoint. If you want to follow from another
waypointyou can initiate the follow then use the WAYPOINT ADVANCE or
FOLLOW FROM HERE soft key to step through the route.
GOTO
WAYPOINT
GOTO
GOTO
CURSOR
STOP
GOTO
GOTO
STOP
GOTO
STOP
FOLLOW
81186_3.book Page 33 Thursday, August 22, 2002 8:23 AM
To Next Page
Loading...
