Chapter 7: Setting Up the System Defaults 7-3
Changing the Set Up
Parameters
• For parameters that have a numeric value, or more than four possible
settings, a scroll listis displayedabove two of the soft keys.
• Some parameters are controlledby a slider thatis displayedabove two
of the soft keys.
• For some parameters, a soft key provides access to a sub-menuof fur-
theroptions.
4. Pressthesoftkeycorrespondingtothedesiredsettingor,forscrolllists,use
the soft keys to scroll forwards or backwards through the list until the
requiredsettingis displayed.This settingis retained when you move the
selection bar on to the nextparameter in the menu list.
For sliders, press the appropriate soft key repeatedly to increase or
decrease the slider valuein individual steps, or press and hold the key to
changethe setting quickly.
5. Once you have set all the requiredvalues, press ENTER to clear the menu
and return to the setup soft keys.
6. Press ENTER, MENU or CLEAR to clear the soft keys and return to the
defaultdisplay.
You can returnall the settings to their original factory settings, if required, by
performing a factory resetas describedin Chapter 9.
81186_3.book Page 3 Thursday, August 22, 2002 8:23 AM
To Next Page
Loading...
