Chapter 2: Getting Started & Adjusting the Display 2-9
Selecting the Mode of
Operation
Radar:
Chart
2. To selecta differentwindow, press either SELECT WINDOWS soft key until
therequired window is highlighted.If necessary, this will togglewindows
on. Press ENTER.
3. To toggle windowsoff,press the WINDOWS OFF ON soft key.
Figure 2-6 shows the half-screen horizontal windows (in radar mode).
Switching Control Between Radar & Chart Screens
In a combined or an integrated system,to switch controlbetween radar and
chart, you can change the full-screen mode usingthe DISPLAY key.
Alternatively, when you have both radar and chart displayedin half-screen
windowsthesoftkey RDR CHRT letsyoutoggleoperatingcontrolbetween the
radar and the chart window.
If a window is active, i.e. control of the cursor via the trackpad is availablein
thatwindow,andyouswitchwindowsoff,controlautomaticallyreturnstothe
full-screen (upper window) mode.
Radar:
Chart:
➤ To change the active window, pressthe RDR CHRT soft key to toggle control
betweenthe radar and chart display. The current active display is highlighted
in red on the RDR CHRT label and the cursor appears in that window.
Returning to the Full-Screen Display
To returnto the full-screen displayyou can turn windows off, as previously
described. Alternatively, to return to full-screendisplay:
➤ Press and hold the DISPLAY key for 2 seconds to return to the currently
selected full-screen(upper window)display
DISPLAY
D4156-3
SELECT
WINDOWS
WINDOWS
OFF ON
ZOOM
OFF ON
DISPLAY
D4156-2
SELECT
WINDOWS
WINDOWS
OFF ON
TARGETS MORE¬HDG MODE
D5668_1
RDR CHRT
GOTO MORE¬ROUTE
D4168-1
RDR CHRT
DISPLAY
81186_3.book Page 9 Thursday, August 22, 2002 8:23 AM
To Next Page
Loading...
