Chapter 2: Getting Started & Adjusting the Display 2-15
Customizing the
Screen Presentation
Options
Thestandardradarpictureis displayedagain,withthe activewaypointjoined
to yourvessel’s position by a dotted line. If the waypoint is off-screen, the
dottedline is extendedto the edge of the radar picture.
Figure 2-7: Active Waypoint on a Radar Display
Custom Options - Chart mode
When chart detailshave been customizedin theChart Set Up menu (as
describedinSection 7.7)theSCREEN softkeycanbeusedtoswitchthecustom
chartoptionsoffor on:
When set to ON, all chart optionsset toCUSTOM in the Customize Chart menu
aredisplayed;when set to OFF, options set to CUSTOM are not shown.
The factorydefault for custom chartoptions is ON.
➤ To switch thecustomized options on or off:
1. Press the SCREEN default soft key.
2. Pressthe CUSTOM softkeyto togglethesettingfromOFF to ON or fromON
to OFF.
To returnto the defaultsoft key display, press ENTER.
D3989-2
Active waypoint
SCREEN
CUSTOM
OFF ON
81186_3.book Page 15 Thursday, August 22, 2002 8:23 AM
To Next Page
Loading...
