2-20 hsb
2
PLUS Series LCD Display
Moving Around the
Chart
Figure 2-9: Changing the Chart Center
Using FIND SHIP
FIND SHIP isusedinchartmodetore-drawthechartwiththevesselatthecenter
and the cursor homed onto the vessel.
When you press FIND SHIP the following occur:
• The chart is re-drawnwith the vessel’s position in the center.
• The cursor is homed onto the vessel position and moves with it.
• When the vessel moves near the edge of the chart window, the chart is
redrawnto place thevessel and cursor at the center again.
• The status bar indicates vessel position,speed and course over ground.
➤ To release the cursor from homed mode press the trackpadto move the cursor
away from the vessel’s current position. The statusbar shows the cursor
position,range and bearing.
Synchronize the Radar and Chart
If you have a combined radar/chartplotter display, with chart and radar
windowson and you have selectedRadar/Chart Synch in Chart Set Up
(Section 7.7, Chart Set Up Parameters),FIND SHIP canbeusedtosynchronize
the radar and chart images. When you press FIND SHIP the followingoccur:
• Thechartisredrawnsothatitscenterpositionmatchesthatoftheradardis-
play.
D4278-1
GOTO SCREENROUTE FIND SHIP
D4160-1
81186_3.book Page 20 Thursday, August 22, 2002 8:23 AM
To Next Page
Loading...
