Raymarine St290 - Button Function; Procedure

Chapter 2: Remote Keypad 4-2-3
ST290 Instrument System Owner’s Handbook
Button function
The the functions assigned to each keypad button are shown in
Figure 2-3 .
Figure 2-3: Remote controls
Procedure
To remotely operate an instrument:
1. Observing the instruments in the relevant instrument group, press the
appropriate button (INSTRUMENT or MAXIVIEW) the necessary
number of times, to select the instrument you want to control
remotely.
Note: Once selected, an instrument returns to local control if there is no
Remote Keypad activity for 5 seconds.
2. Use the appropriate Remote Keypad buttons to operate the selected
instrument (see Figure 2-3 ), in the same way that you would use the
respective buttons at the instrument.
Use this to select a
standard digital
instrument for
remote control
These duplicate the action
of the front panel buttons
on the selected ST290
digital instrument or
MaxiView instrument.
Use this to select a
MaxiView instrument
for remote control
D5909-2
81183_2 S4 chap 2.fm Page 3 Wednesday, May 7, 2003 11:18 AM