2-2-4 Section 2: Using Digital Instruments
ST290 Instrument System Owner’s Handbook
Pop-up option
Selecting chapters
When you are using the pop-up selection option, use the following
procedure to select a new chapter:
1. Press the button to enter Chapter Select mode.
2. Use the button to cycle to the required chapter.
Figure 2-4: Pop-up chapter selection
3. Press either the button or the button, or wait for 5 seconds, to
return to Normal operation. The display shows either the page that
was last used in the selected chapter, or the top page of the selected
chapter, depending which PAGE VIEWED option is set (see Section 7,
System Setup).
The instrument returns to Normal operation.
Selecting pages
To select another page in the selected chapter during Normal operation,
either press the button, to cycle through thepages in one direction, or
hold it down, to cycle through the pages in the opposite direction.
2.3 Using display pages
Formats
The ST290 Graphic Display supports various page formats, so that a
single page on the Graphic Display can comprise either 1, 2, or 4 data
elements, arranged as shown in Figure 2-5 .
HEADING
NAVIGATION
D5673-1
Previous chapter
Current chapter
Next chapter
81183_2 S2.book Page 4 Tuesday, May 6, 2003 8:39 AM
To Next Page
Loading...
