Chapter 5: Adjusting Autopilot Settings 8-5-21
ST290 Instrument System Owner’s Handbook
To set the required correction:
To move to the next setting press the button, or to leave the current
calibration chapter and save all setting changes, press the button.
If you select either NORTH or SOUTH, you must then use the LATITUDE
screen to enter your current latitude, so that the autopilot can provide
accurate course keeping by automatically adjusting the rudder gain
depending on the heading.
Latitude
Note: The LATITUDE screen is available only if you have set Turning Er-
ror Correction to NORTH or SOUTH.
To set the latitude:
1. Use the button to scroll to the AUTO
ADAPT page.
2. Use the or button to select the
required setting. The options are:
• OFF - no correction.
• NORTH - correction for northern
hemisphere.
• SOUTH - correction for southern
hemisphere.
1. Use the button to scroll to the LATI-
TUDE page.
2. Use the or button to select the lat-
itude. The adjustment can be made
from 0° to 80° in 1° steps.
3. To move to the next setting press the
button, or to leave the current cali-
bration chapter and save all setting
changes, press the button.
D6089-1
D6046-1
81183_2 S8.book Page 21 Tuesday, May 6, 2003 9:08 AM
To Next Page
Loading...
