Chapter 3: Setting up Data Displays 7-3-7
ST290 Instrument System Owner’s Handbook
3.4 Setting an instrument profile
You can optimize the operation of each Data Display by using the
PROFILE setup chapter to choose a profile which best suits you. The
choices are:
• SAIL
• POWER
• FULL
• CUSTOM
The structures of SAIL, POWER and FULL profiles are preset, and you
cannot customize any of these. Refer to Section 2, Chapter 3 for details
of the structure of these preset profiles.
The default content of the CUSTOM profile is only the User Setup chapter.
Therefore, when you first select the CUSTOM profile, you must use the
Editing the Custom profile procedure to the pages you want to the profile.
Choosing a profile
To select the required operating profile:
1. In User Setup, select the PROFILE chapter. The name of the current
profile is displayed in the lower display area. The name is flashing to
indicate you can change it.
2. Use the or button to select the required operating profile.
If you selected one of the preset profiles,the profile selection is complete.
Editing the Custom profile
If you select the CUSTOM profile, you can streamline the operation of a
Data Display, by selectingonly the pages you want to see on a day-to-day
basis. All the pages in the Data Display Full profile are available.
To select pages for the CUSTOM profile:
1. With the PROFILE page displayed and CUSTOM selected, press the
button to display the first page of the rollover in the lower display
area.
2. Use the or button as necessary, to select either On,tomakethe
displayed page, available as part of the CUSTOM profile, or OFF, to
exclude it from the CUSTOM profile.
81183_2 S7.book Page 7 Wednesday, May 7, 2003 1:52 PM
To Next Page
Loading...
