Section 1: An Introduction to ST290 1-1-7
ST290 Instrument System Owner’s Handbook
Using instrument buttons
Instruments are controlled by means of front panel buttons. Throughout
this handbook, the following terminology is used to describe how to use
the buttons:
•‘Press’means to press a button until it clicks, then immediately
release it.
•‘Holddown’means to press and hold down a button for a finitetime,
normally stated in the accompanying text.
1.2 Setup requirement
In order to ensure optimum performance on your vessel, your system
must be set up in accordance with the procedures in Section 7, System
Setup, before it is first used after installation.
Do NOT use your system until the setup procedures have been
satisfactorily completed.
Transducer calibration
WARNING:
It is imperative that transducer calibration is completed before the
system is used, to ensure safe navigation.
The transducer calibration procedures optimize the performance of the
transducers with the rest of the system, and so are a mandatory part of the
User Setup procedures. They must be completed in accordance with the
procedures in Section 7 of this handbook.
Autopilot setup
WARNING:
Itis imperativethat autopilotsetup iscompleted beforethe autopilot
is used, to ensure safe navigation.
YourST290 autopilotmust beset upin accordance withthe proceduresin
Section 8 of this handbook.
Using with RayTech
You can connect a Personal Computer running Raymarine RayTech
software to your ST290 system and display RayTech information on
ST290 Graphic Displays.
81183_2 S1.book Page 7 Tuesday, May 6, 2003 8:53 AM
To Next Page
Loading...
