7-3-4 Section 7: System Setup
ST290 Instrument System Owner’s Handbook
3.2 Display responses setup
The RESPONSE setup chapter enables you to set the instrument display
responses and the display update rate.To set the required values:
1. In User Setup, select the RESPONSE chapter.
2. Use the button to select each page in turn and as each setup page is
displayed, use the or button to set the required values:
• Displayresponse values.These are setat SPEED, DEPTH, HEADING,
WIND ANGLE , WIND SPEED and XTE response-setup pages. Values
are from 1 (slowest response) to 15 (fastest response).
• Display update rate. This is set at an UPDATE setup page. Values
are from once per second (set a value of 1.0) to ten times per sec-
ond (set a value of 0.1).
Figure 3-5: Typical RESPONSE setup display
3.3 Favorite chapter setup
Introduction
The FAVORITES setupchapterenablesyou to definewhich pages youwant
as Favorite pages:
• The first Favorites setup page (headed PAGES)isusedtosetthenum-
ber of operational Favorite pages, from 1 to 5.
• The second Favorites setup page (headed LINKED)isusedtosetrela-
tionship of the upper and lower display areas of the operational
Favorite pages. You can set either:
• YES. This sets the upper and lower display areasas linked pairsof
pages(e.g. speed/depth, BTW/DTW etc.) which change together
when a new Favorite page is selected,
or
D5777-1
RESPONSE
HEADING
SETUP
81183_2 S7.book Page 4 Wednesday, May 7, 2003 1:52 PM
To Next Page
Loading...
