Raymarine St290 - Instrument Controls; General Operating Information; First Switch on after Installation

2-1-2 Section 2: Using Digital Instruments
ST290 Instrument System Owner’s Handbook
Instrument controls.
The digital instrument controls are shown in Figure 1-2 .
Figure 1-2: Digital instrument controls
1.2 General operating information
First switch on after installation
When a digital instrument is first switched on after installation, a new
instrument PROFILE screen is displayed.
Figure 1-3: Initial profile select
Select the most appropriate profile for your boat, as follows:
1. Use the or button to select either SAIL or POWER profile.
2. Press the button to apply the profile.
Chapter button
(also used to set backlighting
& contrast)
Page button
Select button
Up button
Down button
D5354-1
DataGraphic
D6063-1
PROFILE
SAIL
81183_2 S2.book Page 2 Tuesday, May 6, 2003 8:39 AM