Chapter 2: Installation Procedures 6-2-19
ST290 Instrument System Owner’s Handbook
Replacing Pod cover
Do not use the Pod with the cover removed,as this could degrade the
EMC performance.
When all connections have been made to the Pod, replace the Pod cover
2.7 Fitting instruments & keypads
General requirements
All ST290 instrument and keypad types are installed in a similar manner,
so generic procedures are given.Adapt theseas necessary for the product
you are installing.
Use the appropriate template, included at Section 11 of this
handbook, to facilitate installation.
Pilot Keypad
If you intend installing an ST290 Pilot Keypad, it is strongly
recommended that you install it in close vicinity to the helm.
Mounting options
ST290 instruments and keypads can be flush mounted or surface
mounted (see Figure 2-18 ).
Figure 2-18: Mounting options
Surface mount
Flush mount
D5718-1
81183_2 S6.book Page 19 Wednesday, May 7, 2003 11:27 AM
To Next Page
Loading...
