Chapter 1: An Introduction to Digital Instruments 2-1-5
ST290 Instrument System Owner’s Handbook
You can disable or enable each alarm function, and you can set levels for
enabled alarms. Refer to Section 2, Chapters 2 and 3, for alarm setup
instructions for Graphic and Data Displays, respectively.
Waypoint arrival alarm
When the waypoint arrival alarm is enabled, an alarm occurs when your
boat reaches a distance you define, from a waypoint. On Graphic
Displays, this distance is shown as a circle around the waypoint.
Man Overboard alarm
If the Man Overboard (MOB) alarm is triggered (from the Man
Overboard Keypad (see Section 4, Chapter 3), the distance and bearing
to the MOB location are displayed.
1.3 Instrument setup
ST290 digital instruments have a wide range of customizing and setup
features, to enable you to set up the best configuration for you and your
boat. The setup features are summarized here, but for details of how to
implement them, refer to Section 7, System Setup.
Most of the setup and customization features are particular to individual
digital instruments, so the chapter and page structure at any one
instrument may well be different from other instruments.
User Setup chapter
A USER SETUP chapter enables you to enter User Setup mode, to set:
• Response times.
• Favorite pages.
• Which operating profile is applied.
• Display options.
• The units used for displaying data.
• Backlighting values.
• Remote control configuration.
User Setupis also used tocalibratethe transducersand setup the autopilot
system.
Refer to Section 7, System Setup, for further details on User Setup.
81183_2 S2.book Page 5 Tuesday, May 6, 2003 8:39 AM
To Next Page
Loading...
