Raymarine St290 - Data Responses; Display Responses; Display Update Rate; Favorite Pages

Chapter 1: Setup overview 7-1-3
ST290 Instrument System Owner’s Handbook
The User Setup routines enable you to:
• Set up the display responses.
• Define Favorite pages and set the operating mode for the Favorite
chapter.
• Select instrument profile and set Custom profiles as required.
• Set various display options.
• Calibrate the transducers (from any Graphic Display).
• Set upautopilot parameters (from any Graphic Display), ifthe ST290
system is connected to an autopilot system. Refer to Section 8, Auto-
pilots, for details.
• Set the data units you require.
• Define basic backlighting control parameters.
Display responses
On each type of digital instrument, you can set the display response and
update rate. The response of an instrument defines its sensitivity to data
changes. The display update rate determines how often an instrument
display refreshes the displayed data. See Term inology on page 7-1-2.
Data responses
You can set the responses for the following data:
• Speed
• Depth
• Heading
• Wind angle
• Wind speed
• Cross track error (XTE)
Display update rate
Available update rates are from once per second to ten times per second.
Favorite pages
The method of setting up the Favorite pages is described in Section 7,
Chapter 2 for the Graphic Display and Chapter 3 for the Data Display.
81183_2 S7.book Page 3 Wednesday, May 7, 2003 1:52 PM