Chapter 3: ST290 Data Display 2-3-11
ST290 Instrument System Owner’s Handbook
Starting the stopwatch
To start the stopwatch:
1. In the Timers chapter, select the STOPWATCHpage.
2. Press the button. The stopwatch starts counting up.
Obtaining lap times
Toobtainalaptime:
1. In the Timers chapter, select the STOPWATCHpage.
2. With the stopwatch counting up, press the button. The lap time is
displayed, and the stopwatch continues counting up in the back-
ground.
3. To return to the real time count, press the button again.
Stopping & resetting the stopwatch timer
To stop the stopwatch:
1. In the Timers chapter, select the STOPWATCHpage.
2. Hold down the button for 1 second. The stopwatch stops counting
and resets to zero.
Race timers
There are three race gun timers, and a race timer. Each race gun timer
counts down from a value determined during set up (see Section 7,
System Setup). The race timer counts up from the start of the race.
To start or stop a race gun timer:
1. In the Timers chapter, select the required GUN timer.
2. Press the button. The timer then counts down from itspreset value
to zero.
Engine chapter
Note: In order to display engine information, the appropriate manufac-
turer’s interface must be installed.
The on-screen chapter title is ENGINE. The pages are summarized in
Table 3-8 .
81183_2 S2.book Page 11 Tuesday, May 6, 2003 8:39 AM
To Next Page
Loading...
