Chapter 2: Installation Procedures 6-2-31
ST290 Instrument System Owner’s Handbook
Setup requirements
WARNING:SETUP REQUIREMENT
Do NOT use ST290 or any associated system before the setup
procedures have been completed.
Before using your ST290 system for navigational purposes, prepare it for
use as follows:
• Calibrate all transducers, in accordance with the procedures in
Section 7, Chapter 2.
• Set up the autopilot system, in accordance with Section 8, Chapter 4.
• Set up each instrument, in accordance with Section 7, Chapters 2, 3
&4.
EMC Conformance
Always check the installation before going to sea to make sure that it is
not affected by radio transmissions, engine starting etc.
81183_2 S6.book Page 31 Wednesday, May 7, 2003 11:27 AM
To Next Page
Loading...
