8-4-8 Section 8: Autopilots
ST290 Instrument System Owner’s Handbook
Setting the rudder damping
Note: You need to adjust the rudder damping value only if the autopilot
‘hunts’ when trying to position the rudder. Increasing the rudder damp-
ing value reduces hunting.
In Pilot Advanced Calibration:
Save the new settings
When youhaveadjusted thesebasicsettings, press the button to leave
Pilot Advanced Calibration and save all setting changes.
Note: You must leave the calibration chapter by using the button to
save all calibration changes. If the unit loses power or is powered off be-
fore this stage then all configuration changes made will be lost.
1. Use the button to scroll to the
RUDDER DAMPING page.
2. Use the or button to select the
required value. The adjustment can be
made from 1 to 9.
3. To move to the next setting press the
button, or to leave the current cali-
bration chapter and save all setting
changes, press the button.
D5991-1
81183_2 S8.book Page 8 Tuesday, May 6, 2003 9:08 AM
To Next Page
Loading...
