7-2-1
ST290 Instrument System Owner’s Handbook
Chapter 2: Setting Up Graphic Displays
2.1 Starting setup
The Graphic Display setup procedures enable you to:
• Local parameters such as responses times, update rate, instrument
profile, display options, data units and default backlighting levels, at
each Graphic Display.
• Set the number of pages and the rollover operation of the Favorite
chapter, at each Graphic Display.
• Calibrate the ST290 system Speed, Depth and Wind transducers
(from any one Graphic Display).
• Set up autopilot parameters (see Section 8 of this handbook), from
any one Graphic Display, when an ST290 Pilot Keypad is being used
to control an autopilot.
EnterUserSetupasfollows:
1. In normal operating mode, press the button to enter Chapter
Select mode, then cycle to the USER SETUP chapter heading.
2. Press the button to display the SETUP ACCESS screen.
Figure 2-1: ENTER SETUP page
3. Hold down the button for 2 seconds to display the USER SETUP
ENTRY screen (see Figure 2-2 ).
4. Within 5 seconds,press the buttonto complete theentry into User
Setup mode. The DISPLAY RESPONSE chapter is displayed.
D5949-1
81183_2 S7.book Page 1 Wednesday, May 7, 2003 1:52 PM
To Next Page
Loading...
