Chapter 1: Preparing for Installation 6-1-11
ST290 Instrument System Owner’s Handbook
• Each product is at least 20 in (500 mm) from radio receiving equip-
ment.
• There is reasonable rear access for installation and servicing.
Wind, Speed & Depth transducers
Cable lengths
The Wind, Speed and Depth transducer types connect to SeaTALK
2
via
an associated Pod. The transducers are supplied with fitted cables, as
follows:
• Wind: 164 ft (50 m)
• Depth/Speed: 45 ft (13.7 m)
Wind
The Wind transducer is supplied with a junction box and a set of spade
terminals. The intended location for the wind transducer must:
• Be as high as possible and away from any equipment which may
shield the transducer or otherwise disturb the air flow.
• Allow reasonable access for installation and servicing.
• Provide a horizontal mounting surface. If a surface (e.g. mast top) is
otherwise suitable but not horizontal, make up a suitable wedged
packing piece to provide the necessary horizontal surface.
Figure 1-6: Wind Transducer dimensions
1.25 in
(31.75 mm)
2.5 in (63.5 mm)
12.2 in (310 mm)
33.5 in (850 mm)
15.2 in (386 mm)
D5602-1
81183_2 S6.book Page 11 Wednesday, May 7, 2003 11:27 AM
To Next Page
Loading...
