7-2-10 Section 7: System Setup
ST290 Instrument System Owner’s Handbook
4. Use the or button to cycle through the available alphanumeric
characters until the character you want is present at the flashing cur-
sor.
5. Press the buttonto accept this character and move the flashing cur-
sor to the next character position.
6. Repeat steps 4 and 5 until the chapter has the required name.
7. Hold down the button for 1 second, to save the chapter name and
leave the chapter name edit mode.
Deleting a chapter
If you delete a chapter, the chapter title and all pages in the chapter are
removed from the custom profile you are editing. However, they are still
available on the system and can be reinstated if required, by carrying out
the Creating a new chapter and Adding a new page procedures.
To delete a chapter:
1. Use the button to highlight the chapter you want to delete.
2. Use the or button to highlight DELETE on the edit menu.
3. Hold down the button for 1 second. The selected chapter is then
deleted from the Custom profile.
Page edit
Adding a new page
To add pages:
1. Withthe chapter edit screen displayed, use the button to highlight
the name of the chapter to which you want to add a page.
2. Press the button to display the page edit screen.
Note: As chapters must contain at least one page, a SPEED page is auto-
matically added to each new chapter. You can change this as necessary.
81183_2 S7.book Page 10 Wednesday, May 7, 2003 1:52 PM
To Next Page
Loading...
