8-5-2 Section 8: Autopilots
ST290 Instrument System Owner’s Handbook
5.2 Accessing Pilot Calibration
To carry out Pilot calibration procedures, use an ST290 Graphic Display,
with PILOT CAL enabled, as follows:
1. Enter the ST290 User Setup mode (see Section 7, System Setup).
2. Use the button to move to the required Pilot setup chapter, either,
PILOT BASIC CAL, PILOT SEATRIAL CAL or PILOT ADVANCED CAL.
3. Adjust the required settings.
General instructions
Throughout this chapter, all button presses are made at the Graphical
Display unless otherwise stated.
When you enter a pilot calibration screen, press the button to move
between the individual calibration pages, or hold down the button to
move backwards through the calibration pages. Use the or buttons
to alter calibration values.
To move to the next setting press the button or to leave the current
calibration chapter and save all setting changes, press the button.
Note: You must leave the calibration chapter by using the button to
save all calibration changes. If the system loses power or is powered off
before this stage then all configuration changes made will be lost.
Figure 5-1: The ST290 Graphic Display
5.3 Pilot Basic Calibration
With the PILOT BASIC CAL chapter selected at an ST290 Graphic Display,
use the button to move to the required setup screen. Typical PILOT
BASIC CAL screens are shown in Figure 5-2 .
Chapter button
(also used to set backlighting
& contrast)
Page button
Select button
Up button
Down button
D5354-1
81183_2 S8.book Page 2 Tuesday, May 6, 2003 9:08 AM
To Next Page
Loading...
