Chapter 1: An Introduction to Digital Instruments 2-1-7
ST290 Instrument System Owner’s Handbook
Ifyouchoose the appropriateinformation for yourFavorite pages,it
should be possible to carry out many of your day-to-day operations
using just the Favorite chapter.
If your ST290 system is connected to a computer running Raymarine
RayTech, you can use the Favorite pages to display RayTech data.
The manner in which Favorite pages are used with Graphic and Data
Displays, is described in Section 2, Chapter 2 and Chapter 3
respectively.
Transducer calibration
WARNING:
It is imperative that transducer calibration is completed before the
system is used, to ensure safe navigation.
Transducer calibration can be carried out from any Graphic Display.
Refer to Section 7, Chapter 2 for details.
Autopilot setup
WARNING:
Itis imperativethat autopilotsetup iscompleted beforethe autopilot
is used, to ensure safe navigation.
If a Pilot Keypad is fitted to your ST290 system, it is essential that the
autopilot setup and commissioning procedures are completed before you
attempt to use the autopilot (see Section 8, Autopilots for details).
Autopilot setup can be carried out from any Graphic Display.
1.4 Backlighting & contrast adjustment
Introduction
You can set the backlighting of ST290 instruments to one of three preset
lighting levels, or switch it off. In User Setup (see Section 7, System
Setup), you can set the brightness level of each preset at each individual
instrument, to any percentage value of the brightest value of the preset
level.
For example, you might wish to set different backlighting levels, for
instruments below and above decks.
81183_2 S2.book Page 7 Tuesday, May 6, 2003 8:39 AM
To Next Page
Loading...
