Raymarine St290 - Chapter 4: Setting up Analog Instruments

7-4-1
ST290 Instrument System Owner’s Handbook
Chapter 4: Setting up Analog Instruments
4.1 Introduction
This Section describes how to set up your analog Wind, Close Hauled
Wind and Compass instruments.
4.2 Analog instrument setup
Wind and Close Hauled Wind instruments
At each Wind and Close Hauled Wind instrument, use the procedure in
Figure 4-1 to:
• Set wind angle response.
• Set wind speed response.
• Set VMG response.
• Apply factory defaults (if required).
81183_2 S7.book Page 1 Wednesday, May 7, 2003 1:52 PM