Chapter 2: Setting Up Graphic Displays 7-2-7
ST290 Instrument System Owner’s Handbook
Choosing a profile
To select the required operating profile:
In User Setup, use the button to cycle to the PROFILE setup chapter.
The PROFILE select page is displayed (see Figure 2-8 ).
Figure 2-8: Profile select page
4. Use the or button to highlight the required operating profile. If
you select either of the CUSTOM profiles, you can choose to edit it at
this point (see Editing Custom profiles,below).
5. To confirm the highlighted profile as the operating profile, press the
button. A is displayed next to the highlighted profile and this
profile is applied to the instrument.
Introduction to Custom profiles
You can use CUSTOM profiles to set up a Graphic Display to show the
particular data and groups of data most convenient to you. You can:
• Create custom chapters.
• Delete chapters.
• Rename any chapter, for example, to summarize its purpose
(DOCKING, CRUISING etc).
• Add any page to any chapter (except the User Setup chapter).
• Delete pages from chapters.
The default content of a CUSTOM profile is only the User Setup chapter.
Therefore, when you first select a CUSTOM profile, you must use the
Editing Custom profiles procedureto add chapters and pages you want in
the profile.
D5941-1
81183_2 S7.book Page 7 Wednesday, May 7, 2003 1:52 PM
To Next Page
Loading...
