Chapter 2: Installation Procedures 6-2-13
ST290 Instrument System Owner’s Handbook
Figure 2-11: Assembling vane, transducer & anemometer
Fitting transducer
The Wind transducer is typically mounted on a mast top
(see Figure 2-12 ), as follows:
1. With the threaded end of the Wind transducer mounting block facing
forwards, mark the position of the two self-tapping screws.
2. Drill two holes using a
5
/
32
in (4 mm) drill bit.
3. Apply sealing compound to the bottom of the mounting block.
Figure 2-12: Fitting Wind transducer
Transducer body
Anemometer
Vane
D6035-1
D6013-1
Fixing screws
Mounting block
Locking ring
FORWARD
81183_2 S6.book Page 13 Wednesday, May 7, 2003 11:27 AM
To Next Page
Loading...
