Chapter 2: Installation Procedures 6-2-15
ST290 Instrument System Owner’s Handbook
Figure 2-13: Using the Wind transducer junction box
Connectthecable to theWindPod, as described under Fitting transducer
Pods.
2.6 Fitting transducer Pods
The installation procedure given here is common to all Pod types and
assumes that SeaTALK
2
and transducer cables have been routed to the
Podlocation,asdescribedunderRunning SeaTalk & SeaTALK
2
cables on
page 6-2-2.
Mast head
Junction box
Pod
D5523-1
81183_2 S6.book Page 15 Wednesday, May 7, 2003 11:27 AM
To Next Page
Loading...
