6-2-16 Section 6: Installation
ST290 Instrument System Owner’s Handbook
Install each Pod as follows:
1. Remove the Pod cover as shown in Figure 2-14 .
Figure 2-14: Removing Pod cover
2. Place the Pod, with the SeaTALK
2
connector block uppermost on the
mounting surface and mark the centres of the fixing holes.
3. Drill three pilot holes for the Pod mounting screws, then secure the
Pod to the mounting surface with the screws provided, as in
Figure 2-15 .
Figure 2-15: Securing Pod
D5607-1
1
2
D5543-1
81183_2 S6.book Page 16 Wednesday, May 7, 2003 11:27 AM
To Next Page
Loading...
