8-3-6 Section 8: Autopilots
ST290 Instrument System Owner’s Handbook
3.4 Product support
Raymarine products are supported by a worldwide network of
distributors and Authorized Service Representatives. If you encounter
any difficulties with this product, please contact either your national
distributor, service representative, or the Raymarine Technical
Services Call Center.RefertoSection 5 of this handbook for details.
Before you consider returning the autopilot, make sure that the power
supply cable is sound and that all connections are tight and free from
corrosion. If the connections are secure, refer to the Fault Finding section
in this chapter.
If you cannot trace or rectify the fault, contact your nearest Raymarine
dealer or Service Center, specifying:
• The course computer serial number, printed under its connector
cover.
• The course computer software version number.
The following illustration shows how to display the software
information:
• At the Pilot Keypad, hold down STANDBY for 4 seconds:
• You will then see a screen display-
ing the course computer software
version and the total number of
hours the autopilot has been used
in Auto mode.
• This information will remain visi-
blefor 10 seconds before returning
to Standby.
Message will "pop-up"
in front of current view
D6047-1
81183_2 S8.book Page 6 Tuesday, May 6, 2003 9:08 AM
To Next Page
Loading...
