7-3-8 Section 7: System Setup
ST290 Instrument System Owner’s Handbook
Figure 3-9: Setting up CUSTOM profile
3. Press the button to display the next page of the rollover in the
lower display area.
4. Repeat steps 2 and 3 until you have displayed all pages, and either
enabled or disabled each one.
This completes the setup for the CUSTOM profile. When the instrument
returns to Normal operation, only the pages you have enabled will be
available, until you either select a different profile or edit the CUSTOM
profile again.
3.5 Display options
The display OPTIONS setup chapter enables you to set up each instrument
to best suit you. To do this:
1. In User Setup, select the OPTIONS chapter.
Figure 3-10:Typical OPTIONS setup screen
2. Press the button to move to each page in turn, and as each page is
displayed, use the or button to select the required option. The
parameters you can set are:
D5775-1
PROFILE
SPEED KTS
SETUP
D6098-1
OPTIONS
HEADING
SETUP
MAG
81183_2 S7.book Page 8 Wednesday, May 7, 2003 1:52 PM
To Next Page
Loading...
