Raymarine St290 - Chapter 3: Setting up Data Displays

7-3-1
ST290 Instrument System Owner’s Handbook
Chapter 3: Setting up Data Displays
3.1 Starting setup
The Data Display User Setup procedures enable you to set:
• Local parameters such as responses times, update rate, instrument
profile, display options, data units and default backlighting levels, at
each Data Display.
• The Favorite chapter operation and content, at each Data Display.
ToenterUserSetup:
1. In Normal operating mode, use the button to scroll to the User
Setup chapter heading. This is shown in the active display area (in
Figure 3-1 , this is the upper area).
Figure 3-1: User Setup chapter heading
2. Hold down the button for 2 seconds to display the User Setup
entry screen (see Figure 3-2 ).
Figure 3-2: User Setup entry screen
D5962-1
SPEED KTS
USER SETUP
D5963-1
USER
SETUP
81183_2 S7.book Page 1 Wednesday, May 7, 2003 1:52 PM