Chapter 2: ST290 Graphic Display 2-2-5
ST290 Instrument System Owner’s Handbook
Figure 2-5: Typical Graphic pages
You can display data either alphanumerically, or as animated graphics, or
intabularform.However, somedata types and somemethods of showing
data are not supported by all page formats.
Changing displayed values
Some Graphic Display pages have values you can change (e.g. to set
alarm levels).
Note: Animated graphic pages use pop-up menus and these are de-
scribed under Animated graphic pages on page 2-2-6.
To change editable values on Graphics Display pages:
1. Press the button to highlight the field you want to edit. If there is
more than one editable field or if you are displaying more than one
element (e.g. quad-element) on which there are different editable val-
ues, use repeated presses of the button, to move the highlight
around the screen, to the field you want to change.
2. When the required field is highlighted, hold down the button for
1 second, so the highlighted field flashes, to show it is in Edit mode.
3. Use either the or button to change the value as required.
4. Hold down the button for 1 second to return to Normal operation.
Typical animated graphic page
Quad-element page
Single-element page
Dual-element page
D5670-1
81183_2 S2.book Page 5 Tuesday, May 6, 2003 8:39 AM
To Next Page
Loading...
