7-2-8 Section 7: System Setup
ST290 Instrument System Owner’s Handbook
Editing Custom profiles
On Graphic Displays, custom profiles are edited in two stages:
• Chapter edit. Enables you to add chapters to, and delete them from,
a custom profile. You can also give each chapter an appropriate name.
• Page edit. Enables you to add pages to and remove pages from each
chapter in a custom profile.
When editing custom profiles, use the button to switch from chapter
edit to page edit, and the button to switch from page edit to chapter
edit.
Starting profile edit
To edit a custom profile:
1. With the PROFILE select page displayed, use the or button to
highlight either CUSTOM 1 or CUSTOM 2, as required.
2. Hold down the button for 1 second, to enter custom edit mode.
When you enter custom edit mode, the chapter edit screen is displayed. If
this is the first time you are editinga profile, the only chapter in the profile
is the User Setup chapter, as in Figure 2-9 .
Figure 2-9: Chapter edit screen
Chapter edit
The chapter edit screen enables you to:
• Create a new chapter. (see Creating a new chapter).
• Edit the name of any chapter (see Changing chapter name).
• Delete any chapter (see Deleting a chapter), except the User Setup
chapter.
Chapter edit menu
Use these to select
chapter edit option
D5838-1
81183_2 S7.book Page 8 Wednesday, May 7, 2003 1:52 PM
To Next Page
Loading...
