Chapter 2: Setting Up Graphic Displays 7-2-33
ST290 Instrument System Owner’s Handbook
Checking operation
The SET LAMPS field enables you to cycle through the backlighting levels
to check that they levels are as required at each instrument in the system,
To do this:
1. With the User Setup LAMPS page displayed, use the or button to
select SET LAMPS.
2. Hold down the button for 1 second to enable the lighting check.
3. Use the or button to select each lighting level in turn, and check
all instruments.
4. Hold down the button for 1 second to end the lighting check.
If the levels at any instrument are unsatisfactory, carry out the Setting
levels procedure (above) at the relevant instrument(s), to correct the
levels.
2.10 Leaving setup
To leave User Setup:
1. Use the button to move to the USER SETUP EXIT screen.
2. Hold down the button for 2 seconds. The instrument returns to
Chapter Select mode.
3. Either press the button or wait for 5 seconds, to return to Normal
operation.
81183_2 S7.book Page 33 Wednesday, May 7, 2003 1:52 PM
To Next Page
Loading...
