Chapter 3: Setting up Data Displays 7-3-9
ST290 Instrument System Owner’s Handbook
• HEADING (as in Figure 3-10 ). Select either MAG(netic) or TRUE.
• CHAP TITLES. Select either on or OFF.
• The page that is firstdisplayed when you select a new chapter dur-
ing Normal operation. You can set this as either TOP PAGE (thetop
page in the chapter) or LAST VIEWED (the page that was last dis-
played when the chapter was last used).
• KEY BEEP. Select either on or OFF.
• Race timers, GUN 1, GUN 2 and GUN 3. Use the procedure under
Setting race gun timers below, to set each of these.
• SPEED , DEPTH, WIND SPEED and DISTANCE units resolution. The
degree of resolution is dependent on data type and value (either
1.0, 0.1 or 0.01).Notethatforsomedatavalues,theimplementa-
tionof this feature may be limited by the constraints of the display.
• TIME OFFSET. Set to give local time.
• TIME FORMAT. Choose 12 or 24 hour clock.
• MONTH TEXT. Choose YES or nO.
• DATE FORMAT. Choose USA or EU.
• REM GROUP. Enables you to allocate the instrument as part of a
remotely controlled group. Refer to Setting remote control con-
figuration,below.
• REM SEQUENCE. Enables you to define the sequence in which the
instrument is selected within its remote group Refer to Setting
remote control configuration,below.
• REM LINK. Enablesyou toallocatea RemoteKeypad to controlthe
remote group. Refer to Setting remote control configuration,
below
Setting race gun timers
To set any of the race gun timers:
1. In the OPTIONS chapter, select the required GUN timer page.
2. Press the button for 1 second, to enter Edit mode. The seconds
value flashes.
3. Use the or button to set the required seconds value.
4. Press the button for 1 second, to edit the minutes. The minutes
value flashes.
5. Use the or button to either set the required minutes value.
6. Press the button for 1 second, to leave the edit mode and save the
new value.
81183_2 S7.book Page 9 Wednesday, May 7, 2003 1:52 PM
To Next Page
Loading...
