Raymarine St290 - Setting Data Resolution

Chapter 2: Setting Up Graphic Displays 7-2-15
ST290 Instrument System Owner’s Handbook
Figure 2-16: Race timers setup
2. Hold down the button for 1 second to enter edit mode. The
selected option then flashes.
3. Use the or button to set the selected gun to the time you want.
4. Hold down the button for 1 second to save the value.
Setting data resolution
Youcanset the numberof decimal places in displayed data. The degree of
resolution is dependent on data type and value.
Figure 2-17: Data resolution setup
To set the resolution of each parameter:
1. With the resolution page displayed (Figure 2-17 ), use the or
button to highlight the option you want to set.
2. Hold down the button for 1 second to enter edit mode. The
selected option then flashes.
3. Use the or button to set the selected option to the resolution you
want.
4. Hold down the button for 1 second to save the value.
D5943-1
D5944-1
81183_2 S7.book Page 15 Wednesday, May 7, 2003 1:52 PM