8-5-22 Section 8: Autopilots
ST290 Instrument System Owner’s Handbook
Autopilot reset
WARNING:
Do NOT use this feature unless advised to do so by a Raymarine
dealer. If you complete a reset you will lose ALL autopilot
calibration settings. You will then need to repeat the autopilot
commissioning process.
Selecting an autopilot reset will reset all of the settings in Basic
Calibration,SeatrialCalibration and Advanced Calibration to the factory
default values.
4. To save the setting change, turn the course computer power off and
back on.
To reset the autopilot:
1. Usethe buttonto scrolltotheRESET
PILOT page.
2. Use the button to set the CURRENT
SETTING ON.
3. Press the button. You will then see
an ARE YOU SURE? message. Either:
• Press the button again to select
YES and reset the autopilot.
OR
• If you want to cancel, ensure that
NO is selected and press the
button to leave Pilot calibration.
D6036-1
D6034-1
81183_2 S8.book Page 22 Tuesday, May 6, 2003 9:08 AM
To Next Page
Loading...
