Raymarine St290 - Page 230

7-4-2 Section 7: System Setup
ST290 Instrument System Owner’s Handbook
Figure 4-1: Setting up Wind and Close Hauled wind instruments
Calibration
entry
screen
AND
Press
simultaneously
Not used
D5723-1
Hold down
AND
for approximately 12 seconds
Boat
show
mode
Do NOT set to
on (bS1)
Wind
angle
response
to set required value
(A1 to A15)
Press
OR
Wind
speed
response
VMG
response
Factory
defaults
to set required value
F1 = factory defaults
F0 = current settings
After hold down
of 2 seconds
After hold down
of 12 seconds
Software
version
After hold down
of 4 seconds
AND for 2 secondsTo accept settings & exit calibration, hold down
to set required value
(S1 to S15)
Press
OR
to set required value
(1 to 15)
Press
OR
Press
OR
(not available on
Close Hauled
Wind instrument)
81183_2 S7.book Page 2 Wednesday, May 7, 2003 1:52 PM