Raymarine St290 - Page 193

Chapter 2: Setting Up Graphic Displays 7-2-11
ST290 Instrument System Owner’s Handbook
Figure 2-12: Page edit
3. Highlight the name of the page immediately above the point at which
you want to insert a new page.
4. Use the or button to highlight NEW PAGE on the page edit menu.
5. Hold down the button for 1 second. A new (SPEED)pageis
inserted below the highlighted chapter. You can either:
• Accept this page as it is
or
• Use the Selecting page information procedure, to show different
data.
Selecting page information
To set the required data on a custom page:
1. With thepage edit screendisplayed, use the button to highlight the
page you want to change.
2. Use the or button to highlight EDIT on the edit menu.
3. Hold down the button for 1 second so the highlighted page name
flashes to indicate you can change it.
4. Use the or button to step through the available pages, until the
name of the page you want is displayed in the flashing field. All the
pages in the Graphic Display Full profile are available.
5. Hold down the button for 1 second to save this configuration.
Page name
D6064-1
Selected chapter
Page edit
menu
81183_2 S7.book Page 11 Wednesday, May 7, 2003 1:52 PM