6-2-24 Section 6: Installation
ST290 Instrument System Owner’s Handbook
Figure 2-25: Surface mounting, step 3
Figure 2-26: Surface mounting, step 4
3 Drill 0.15 in (4 mm) holes for fixing studs.
D5716-1
4 Feed cables through mounting surface, bracket and
seals, then connect to instrument or keypad. Use
studs and thumb nuts to secure instrument or
keypad to mounting surface.
D5717-1
81183_2 S6.book Page 24 Wednesday, May 7, 2003 11:27 AM
To Next Page
Loading...
